§ 50-357. Monuments (corner markers).

(a)

Installation. As required by this article all monuments must be installed by the subdivider. Upon completion of subdivision streets, sewers, and other improvements, the subdivider shall make certain that all monuments required by the town are clearly visible for inspection and use. Such monuments shall be inspected and approved by the town before any improvements are accepted by the town council.

(b)

Location of steel pins. Steel pins shall be used as monuments at all street corners and at all points where the street line intersects the exterior boundaries of the subdivision and at right angle points and points of curve in each street. Such monuments shall meet the specifications of the state department of transportation.

(c)

Location of iron pipe. All other lot corners shall be marked with iron pipe not less than three-fourths inch in diameter and 24 inches long and driven so as to be flush with the finished grade. When rock is encountered, a hole shall be drilled four inches deep in the rock, into which shall be cemented a steel rod one-half inch in diameter, the top of which shall be flush with the finished grade line.

(Ord. of 6-29-1977, § 412)

(Ord. of 6-29-1977, § 412)